Recommended Posts

Posted

I left Denver a week and a half ago for Aruba. Before I left I got a couple of 62% Boveda packs for my travel box. I checked the packs today and they are saturated. Humidity here is typically around 80-90%. I’m thinking I should have let them dry a bit before I left home, but it’s obviously too late for that. Is there any slick way of drying out these things in a high humidity climate? Thanks!

Posted
3 minutes ago, stogieluver said:

Sounds like they're doing what they're supposed to do.

The cigars seem soggy. I’m afraid they may be too saturated to be working. Is that a possibility after just a week and a half?

Posted
10 minutes ago, Ritch said:

Pick up some silicon dessicent packs. Normally used in packaging.

+1 on this. I've researched this before on the internet and several people recommend putting them in the oven at very low temperature for a certain amount of time. That might work but I would think there might be a risk of damage to the pack with this method. So I used desiccant packs in a ziplock with my boveda and worked great. 

Posted
13 minutes ago, Ritch said:

Pick up some silicon dessicent packs. Normally used in packaging.

Good idea.  I would look for a handful of kitty litter if it could be found.  

Posted

I got some for last summer when my bovedas were struggling. Put two in the humidor and it brought it under control so I could take them out and let the bovedas do their job

Posted
4 hours ago, Ritch said:

Pick up some silicon dessicent packs. Normally used in packaging.

This sounds like just the ticket. Thanks. 

Posted
13 hours ago, Shelby07 said:

I left Denver a week and a half ago for Aruba. Before I left I got a couple of 62% Boveda packs for my travel box. I checked the packs today and they are saturated. Humidity here is typically around 80-90%. I’m thinking I should have let them dry a bit before I left home, but it’s obviously too late for that. Is there any slick way of drying out these things in a high humidity climate? Thanks!

Wow.....I thought the boveda packs absorb and release the humidity?! If you left the cigars you brought with you in some Tupperware with some cedar in your hotel room I would think they would be fine. That’s what I use 62% boveda. 

Posted

I have this problem in Asia as well.  Usually, just leaving them in the air conditioned hotel room brings them back into line, without drying them so fast that they get crunchy.  Eventually I lose the battle and the membranes give it up and start leaking, but that's after 2 or 3 years of cycling through over saturation.

Posted
9 hours ago, Jal154 said:

Wow.....I thought the boveda packs absorb and release the humidity?! If you left the cigars you brought with you in some Tupperware with some cedar in your hotel room I would think they would be fine. That’s what I use 62% boveda. 

Yes, they do. I have a case that holds about 15 cigars. They were smoked in the first few days. As I smoke them I replace them with cigars purchased locally. The humidity here is high. At LCDH it is 85% according to the in store hydrometer. So as I replace them the boveda packs are working to get the moisture content down. The packs seem to be pretty much saturated. 

Posted

Lay them all out and turn on the ac. In the highest of humidity locales I have noticed that hygrometers register in the 50%’s when indoors with ac blasting. 

Posted

No AC availavle so I have a Tupperware of desiccant beads at home.  They are dark blue and turn pale orange when they absorb moisture.  Then you dry them out in the oven to "recharge" their dryness.

Anyway, if my house is too humid, I'll drop a few "wet" boveda with them for a week or so, then use one of these "dryer" 62% boveda in my humid, so it can suck up the excess moisture.  Keep doing this process as needed.  Just the inverse of what I do when its dry (Tupperware with distilled water cup). 

Buy a jug.  They are cheap and will come in handy for other things (storing electronics in garage was my latest application)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.

Community Software by Invision Power Services, Inc.